Precautions for operation of plate shears

Attention to use

1. Start the plate shearing machine to run idle for several cycles to ensure that under normal conditions, the plates with different thicknesses can be cut thin to thick. Ensure that the user is familiar with the performance of the shear.

2. The blade clearance must be adjusted when the thickness of the plate is different. If the corresponding blade clearance is adjusted, the blade durability will be affected.

3. Switch on the pressure gauge switch in the shearing process, observe the oil pressure value, the pressure should be less than 20MPa when cutting 12mm plate. This remote pressure regulating valve No9 is set at 20-22mpa when it leaves the factory. Users must abide by this regulation. It is allowed to increase the pressure for the shear exceeding the specified material surface cause damage to the machine.

4. Sound balance during operation. If there is noise in the shearing machine, stop the machine for inspection.

5. When the shearing machine is operating, the temperature of the oil tank is increased to less than 60 degrees, it will be shut down for rest.