Contact: Li Shijun (13940547998) with wechat
Contact: Li Ying (15502475265) with wechat
Tel: 024-25870279
Fax: 024-25870279
E-mail: 1412909433@qq.com
Postcode: 110025
Address: No.28-1, Zhenxing 7th Street, Hutai new town, Shenyang, Liaoning Province
Sales address: Gate 3, No. 32, Baogong North Street, Tiexi District, Shenyang City, Liaoning Province
website: en.sywhddy.com
It is very important for the parts of hydraulic bar shear machine to prevent rust. The maintenance of hydraulic components is an important thing. In order to keep the hydraulic system clean, the maintenance of hydraulic components should be done on schedule. The main hydraulic components of the hydraulic brake bar shear machine include hydraulic circuit, oil filter, air filter hydraulic pump. How to maintain these components of the hydraulic system
a. Hydraulic lubrication circuits
This is to avoid the hydraulic pump failure caused by the lack of oil in the hydraulic system. The oil level in the oil tank of the hydraulic brake bar shear machine should be reflected regularly. If the oil level is lower than the middle line of the oil mark, the oil should be quickly filled to the middle line of the oil mark. In addition, after 500 hours of application, the oil should be changed once. In the future, the oil must be changed every 2000 hours. The oil pressure of the hydraulic bar cutting machine must meet the requirements. The oil tank of hydraulic brake type bar shearer must be washed thoroughly every time the oil is changed.
b. Oil filter
The cleaning of the oil filter must be done in place. Wash the oil leakage device installed at the oil inlet end of the oil pump of the hydraulic brake bar shear machine regularly, wash it with gasoline trichloroethylene solution. After 8 days, the hydraulic brake bar cutting machine is washed once every 30 days. If the oil filter assembly of hydraulic brake bar shear machine is seriously damaged, it must be replaced in time.
c. Air filter
Wash the air filter regularly. The air filter is normally installed on the oil tank of the hydraulic brake type bar cutting machine. Generally, the hydraulic brake bar shear should be washed once 500 hours after it is put into use. It should be washed with gasoline, vinyl chloride other solutions. In the future, it must be washed every 1000 hours.
d. Hydraulic pump
This should fully do a good job in the hydraulic system of the hydraulic brake bar shear machine maintenance things.
