Precision bar cutting machine manufacturer
your current location : Home page >> News >> Technical Consultation

Contact

Shenyang Wanhaide Forging Machine Tool Co., Ltd

Contact: Li Shijun (13940547998) with wechat

Contact: Li Ying (15502475265) with wechat

Tel: 024-25870279

Fax: 024-25870279

E-mail: 1412909433@qq.com

Postcode: 110025

Address: No.28-1, Zhenxing 7th Street, Hutai new town, Shenyang, Liaoning Province

Sales address: Gate 3, No. 32, Baogong North Street, Tiexi District, Shenyang City, Liaoning Province

website: en.sywhddy.com

Brief introduction to the usage precautions of Shearer

2020-05-02
times

Shears can save management costs for manufacturers improve work efficiency, so many enterprises will use it. Today, I'd like to share its usage precautions.

Correct usage of Shearer

1. The worktable for receiving delivering materials should be level with the lower part of the cutter, the length of the worktable can be determined according to the length of the processing material.

2. Before starting, check confirm that there is no crack on the cutter, the bolt of tool holder is tight, whether the protective cover is secure. Then turn the pulley by hand, check the gear engagement clearance adjust the cutter clearance.

3. After start-up, it is necessary to run without load check that all transmission parts bearings are running normally before operation.

4. When the machine does reach the normal speed, the material shall be cut.

5. The shear diameter strength shall exceed the bar diameter bar section area specified in the mechanical nameplate.

6. When cutting low alloy steel, the high hardness cutter should be replaced, the shear diameter should meet the requirements of the mechanical nameplate.

7. During operation, avoid cleaning the broken ends sundries near the cutter by hand. No non operators are allowed to stay around the bar swing cutter.

8. In case of abnormal operation, abnormal noise cutter deflection, the machine shall be shut down for maintenance immediately.

9. After operation, the power supply should be cut off the sundries between the steel cutters should be cleaned lubricated.

Notes for use of Shearer

1. Before operation, the staff should check whether there is leakage, whether the power supply is used correctly, whether there is a good connection between the components, whether the blade is firm, whether the body is well protected, can be used only after confirming that there is no problem.

2. Before using it, try to use the empty car to see if there is any problem. If there is no problem, you can start the operation formally.

3. When cutting the round steel, it is necessary to push the round steel tightly. After the movable blade is returned, the round steel will be sent to the knife edge for cutting. It is forbidden to process the steel beyond the specification super hard.

4. When cutting the short material, two people should operate together, the later generations should listen to the command of the predecessors, cooperate coordinate, can drag pull arbitrarily.

5. Do adjust, clean check the machine when it is in operation. These can only be operated when it stops running.

6. When changing the blade, it is necessary to cut off the power before replacing it. After replacement, keep it clean tidy, lock the gate box.

Bar cutting machine

tag

Latest browse:

Fast Navigation
Navigation