Application requirements of bar cutting machine

Bar shearing machine is a kind of tool used to shear steel bar. With the development of science technology industry, it has been widely used. The use of this machine greatly improves the efficiency of work, we should pay attention to certain matters when using, otherwise accidents will occur. So what should be paid attention to when using bar cutting machine? The following bar cutting machine manufacturers to introduce to you.

1. When we install the machine, we should install it in a strong reliable place, keep the horizontal position, so that it will shake when working. The machine shed shall be set up for outdoor operation, the shed shall have a place for stacking raw materials semi-finished products. We should have a reliable foundation when using the fixed machinery, wedge the walking wheel when the mobile machinery works.

2. Before starting, check confirm that there is no crack on the cutter, the bolt of the tool holder is tight, the protective cover is firm. Then turn the belt pulley by hand to check the gear meshing clearance adjust the cutter clearance. After start-up, it is necessary to run without load, check that all transmission parts bearings are in normal operation before operation.

3. The lower part of the cutting tool of the worktable for receiving delivering materials is kept horizontal, the length of the worktable can be determined according to the length of the processing material. When the machine is cutting low alloy steel, the high hardness cutter should be replaced immediately, the shear diameter should meet the requirements of the mechanical nameplate. It is allowed to shear the round bar with diameter strength exceeding that specified in the mechanical name plate.

4. When the machine does reach the normal speed, the material shall be cut.

5. During operation, it is strictly forbidden to remove the broken ends sundries near the cutter by hand.

The above is about the bar cutting machine when using the requirements. Compared with other cutting equipment, bar cutting machine has the characteristics of light weight, less energy consumption, reliable work high efficiency. In normal use, we should pay attention to the maintenance maintenance of the machine, so as to extend the service life of the machine.