Maintenance methods of plate shears

If you want to extend the service life of the plate shears, then we have to understand the knowledge of the maintenance maintenance of the plate shears, master the maintenance methods of the plate shears, which can only prolong the service life of the plate shears, but also improve the working efficiency of the shear.

What are the maintenance methods?

1. To strictly follow the correct way to operate.

2. Before starting the machine, the lubricating oil must be added quantitatively, regularly at a fixed point according to the requirements of the lubrication chart, the oil should be free of precipitation. Check confirm whether the oil quantity nitrogen gas volume of each lubricating oil tank meet the requirements. Use manual refueling refuel according to regulations.

3. The machine tool must be kept clean the parts without paint should be rust proof grease proof.

4. Be sure to check whether there is lubricating oil on the surface of machine guide rail lead screw, ensure that it is lubricated.

5. Be sure to check the hydraulic system in the machine.

6. Be sure to check the filter screen in the electrical cabinet clean the dust adhered to it in time.

7. Be sure to check all the buttons the functions of the selector switch. The contact points should be good, no leakage, the damaged ones should be replaced in time.

8. Be sure to check all transmission parts for looseness, check the meshing of gears racks, replace adjust them when necessary

9. Always check whether the handle, knob, button V-belt are damaged. If the damage is serious, it should be replaced in time, the spare parts should be reported for supplement.

10. Always check repair the fuse, switch handle, make sure they work normally

11. It is forbidden for non staff to operate the equipment, it must be stopped when people leave the machine.

12. Observe all conditions at any time during the work, press the emergency stop button immediately if there is any abnormality.

13. Leave the machine for a long time to turn off the power supply to prevent non professional staff operation.