What is the reason why the shearer can be stored normally for a long time?

Shears in the application process, a long time storage, the shearer is normal, so how to solve this situation? The following bar cutting machine manufacturers together to understand it.

1. If the round steel Shearer has been used for a long time, it may fail if it is suddenly re started. The correct way is to find the company's relevant professional technical personnel to carry out maintenance adjustment before application.

2. It has been used for a long time no corresponding maintenance measures have been taken, resulting in the corrosion of round steel shears, which makes the rotation of each component flexible. In this case, it is recommended to scrub the equipment with salt free grease lubricant before use.

3. The main engine does start because the main stop button the main engine stop button do return properly are damaged. The solution is: first try to move the main stop button stop button several times to see if they have any reaction, check whether there are problems caused by poor contact. If the inspection is the above two cases, then it is necessary to remove the main stop button stop button that cannot return to the original position for maintenance Repair replace.

4. The main engine does start due to the button return in place electric shock damage. The solution is to replace the button electric shock switch.

5. The main engine does start due to the tripping disconnection of the thermal relay. The solution is to press the thermal relay button again according to the operating procedures of the shearing machine.

6. The main machine does start because the counter sends the preset quantity does press the reset switch to zero. The solution is: press the reset switch according to the operation procedures of the steel bar straightening shearing machine, reset the counter to "0".