Matters needing attention before after using bar cutting machine

In order to improve the utilization rate of the equipment prevent the occurrence of safety accidents, the operation of the bar shearing machine should be carried out in strict accordance with the equipment safety operation regulations.

So, how to operate it? What should I pay attention to? We should pay special attention to the following points:

1. Check whether the protective device of bar shearing machine is in good condition;

2. Whether the equipment connecting bolts are loose;

3. Whether the compressed air is normal;

4. Whether the automatic lubrication system is in good condition;

5. Whether there are foreign matters between the upper lower blades whether the blade gap is properly adjusted;

6. If the warm shear production line, the blade should be preheated to 100 ~ 150 ℃ in winter before normal operation;

7. It is forbidden to use the equipment over load shear bars with higher tensile strength beyond the allowable diameter range of the machine tool;

8. The minimum length of the shear bar shall be less than the distance between the center of the pressing head on the blade (the center of the upper pressing head must be on the bar before shearing);

9. In case of continuous impact, car sliding electrical failure, the equipment shall be stopped immediately to eliminate the equipment fault;

10. Cut off the power supply, close the air valve stop the slide block at the top dead center after the work of the bar shearer is completed, so that the equipment is in the stop state;

Through the above 10 points, I believe you have a certain understanding of how to use the bar cutting machine correctly the matters needing attention before after use.